Toilet Installation in North Bay
Toilet installation in North Bay is a same-week service from Poly-B Plumbing for homes, cottages, rental units and renovations in North Bay, Callander, Sturgeon Falls, Powassan and the surrounding communities. A proper toilet installation is the removal of the old unit, inspection and repair of the flange and subfloor, a new code-approved supply line and shut-off, the right seal for the application, and a set that does not rock, leak or run. Most installs take 60 to 90 minutes including cleanup and are quoted flat-rate in writing. Call 705-345-6616.
Service hours
- Monday to Thursday7:00 am to 7:00 pm
- Friday7:00 am to 5:00 pm
- Saturday and SundayClosed
Emergency service is available during business hours only. Members of the $49-per-month plan get priority scheduling.
Choosing the right toilet for a North Bay home
| Type | Best for | Installation notes |
|---|---|---|
| Two-piece, standard height | Most replacements; the widest range of parts | Confirm the rough-in: 12 inches is standard, older North Bay homes are sometimes 10 |
| One-piece | Easier cleaning, tighter bathrooms | Heavier to set; one person cannot do it well |
| Comfort or chair height | Accessibility, aging in place, knee and hip issues | About two inches taller; often paired with grab bars |
| Dual-flush and 4.8 litre models | Water bills and septic systems | Ontario’s building code caps new toilets at 6 litres per flush; most quality models now use 4.8 |
| Wall-hung | Renovations wanting floor space and easy cleaning | Needs an in-wall carrier set at rough-in; not a swap |
| Bidet seat or smart toilet | Comfort and accessibility | Needs a power outlet within reach and a cold-water tee; Poly-B confirms both before install day |
| Macerating or upflush toilet | Basement bathrooms below the sewer line | An alternative to an ejector pit; noisier, but no concrete cut |
Why the flange decides whether the install lasts
Most toilet leaks Poly-B Plumbing sees in North Bay are at the floor, not the tank, and most of those trace to a flange that was cracked, sitting below the finished floor after new tile, or screwed into soft subfloor. A new toilet set on a bad flange rocks, breaks the seal within months, and lets water into the subfloor where it rots quietly. Poly-B checks the flange height and condition on every install, replaces or reinforces it where needed, uses a flange extender when new flooring raised the floor, and sets the toilet on a wax or waxless seal chosen for the application. Old supply lines are not reused unless they are recent braided lines; a new code-approved line and a working shut-off go in every time.
Toilets on septic systems
Many homes around Corbeil, Astorville, Bonfield, Powassan and the lake roads are on septic. A low-volume toilet is the right choice there: less water into the tank means less disturbance of the settled solids and a longer field life. Poly-B is licensed for septic as well as plumbing, and will say so if a cottage’s tank sizing or a failing field is the real reason the toilet is slow.
What a toilet installation costs in North Bay
Poly-B Plumbing quotes toilet installations flat-rate, in writing. The price depends on:
- Who supplies the toilet. Bring your own, or Poly-B supplies an American Standard or Toto model that fits the rough-in and the room.
- Flange condition. A sound flange is the base case; a cracked flange, a flange below new tile, or a soft subfloor adds a repair.
- Shut-off and supply. Replaced every time; a seized valve that has to be cut out adds a little.
- Type. A wall-hung carrier or a macerating unit is a different job from a floor-mounted swap.
- Extras. Bidet seat wiring coordination, grab bars, or a second toilet in the same visit.
Property managers doing rental turnovers can book several units in one day. Members of the $49-per-month plan get priority scheduling and 10 percent off.
Why a bad install shows up later
- A rocking toilet cracks the seal and the flange bolts loosen further with every use.
- Silicone around the base hides a floor leak until the ceiling below shows it.
- A reused supply line splits, and a toilet supply line runs all day when nobody is home.
- Wrong rough-in distance leaves the tank an inch off the wall or the toilet hard against it.
- A flange sitting low after new flooring gives the seal nothing to compress against.
Plumber (306A) is a compulsory trade in Ontario regulated by Skilled Trades Ontario, and connecting a fixture to the drainage system is certified work. Poly-B’s owner holds Red Seal journeyman certification, is licensed for plumbing, wells, septic and backflow prevention, and carries up to $5 million in liability insurance.
Sources: Skilled Trades Ontario, Plumber (306A); Ontario Building Code, Part 7 Plumbing.
How Poly-B installs a toilet
Remove the old fixture
Water off, tank and bowl drained, old toilet out safely, floor prepped.
Inspect and prep the flange
Height, cracks, bolt slots and subfloor checked; replaced, reinforced or extended where needed.
New supply and shut-off
Code-approved supply line and a working valve, every time.
Set and seal
Wax or waxless seal chosen for the application, toilet set level with no rock, bolts trimmed and capped.
Test and clean
Leaks, flush quality, fill valve and seal checked; workspace cleaned.
Rental turnovers and accessibility conversions
Property managers in North Bay book Poly-B Plumbing for several units in one day at turnover, when a running toilet is the difference between a rentable unit and a water bill. Comfort-height toilets, grab bars set into blocking and a bidet seat with its outlet are the usual accessibility package, and Poly-B coordinates the outlet with the electrician so the seat is powered the day it is installed. Cracked tanks and leaking bases are replaced as emergencies during business hours, because a toilet that leaks at the floor is soaking the subfloor of the unit below.
What North Bay customers say
“This was the second time Poly-B has done work at my house. First was a service line replacement, this was a toilet issue. The prices are good, I would recommend this company 100%.”Phyllis Wall, Google review, May 2025
“Excellent professional job!”Debbie Moss, Google review, May 2025
Where Poly-B installs toilets
Toilet installation questions from North Bay homeowners
Can Poly-B supply the toilet, or do I buy it?
Either. If you already have one, Poly-B Plumbing installs it. If not, Poly-B supplies and recommends American Standard or Toto models that fit your rough-in and bathroom.
What if my old flange is damaged?
Poly-B Plumbing repairs, replaces or extends the flange during the install. A toilet is never set on a broken or low flange just to make it work.
How long does a toilet installation take?
Most installs take 60 to 90 minutes start to finish, including cleanup. A flange replacement or a wall-hung carrier adds time.
Does Poly-B install bidet seats and smart toilets?
Yes. Poly-B Plumbing installs bidet seats, smart toilets and wall-mounted units, and confirms the power outlet and water tee needed before install day.
How do I know if my rough-in is 10 or 12 inches?
Measure from the finished wall behind the toilet to the centre of the closet bolts. Twelve inches is standard; some older North Bay bathrooms are ten, and a 12-inch toilet will not fit. Poly-B Plumbing checks before ordering.
Book a toilet installation in North Bay
Monday to Thursday 7 am to 7 pm, Friday 7 am to 5 pm. Measure the rough-in before you buy, or ask Poly-B to supply the right one.
Call 705-345-6616 Request a free online quote
Poly-B Plumbing, 1107 Yellek Trail, North Bay, ON P1B 8G5.